Initialization failed because the transport refused to open initial Addresses.

Your computer cannot access the network because its name does not match an IP address.

This could be caused by an incorrect computer name, or your network adapter might need to be reset.

To determine whether your computer’s name is correct, at the command prompt, type nbtstat -n, and then press ENTER.

If the computer name is correct, no further user action is required.

If the name is incorrect, try resetting the network adapter.

To verify that the WMI Performance Adapter service is enabled

1. In Control Panel, double-click Network Connections.
2. Double-click WMI Performance Adapter.In Control Panel, double-click Network Connections.
3. On the shortcut menu, click Disable.
4. Right-click the network adapter again, an then click Enable.