Firewall rules “host” logic

I need a solution


I’ve already found , but still have small question left.

I want to create firewall rule, which will allow specific traffic only if (local IP) and (local MAC) will match specific values.

Following mentioned article, “The hosts that you define on either side of the connection (between the source and the destination)” use OR condition, and “Selected hosts” use AND condition.

That’s fine to understand if we are talking about matching only IP-addresses, for example (we take any IP from “Local” block, any IP from “Remote” block, and connect them with AND statement).

But, in my case, both my conditions (local IP and local MAC) are on the same side – does it mean, that only “OR” is possible? Any way I can connect both this rules with “AND”?



Leave a Reply