7020856: How to Set GWIA to Send Outbound Mail Through the SMTP Scanner

This document (7020856) is provided subject to the disclaimer at the end of this document.


SMTP Scanner only


: How to set GWIA to send outbound mail through the SMTP scanner Answer/


By default the GWIA will send outbound mail on it’s own, entirely bypassing the SMTP scanner. However, if you would like to send mail out through the SMTP scanner, (reasons can range from wanting to scan outbound mail, to wanting to use outbound mail for GWAVA’s learning system, or just wanting everything going out and coming into the same place) you will need to put the ‘Relay Host for outbound messages’ setting into the GWIA settings in ConsoleOne.

Please see the following screenshot for further instrucitons:

The IP address there should be the IP of your GWAVA SMTP scanner.

Additional Information

This article was originally published in the GWAVA knowledgebase as article ID 1293.


This Support Knowledgebase provides a valuable tool for NetIQ/Novell/SUSE customers and parties interested in our products and solutions to acquire information, ideas and learn from one another. Materials are provided for informational, personal or non-commercial use within your organization and are presented “AS IS” WITHOUT WARRANTY OF ANY KIND.


Leave a Reply